Metal wire drawing machine: it belongs to the pre-processing equipment for the production of metal products such as standard parts. The diameter, roundness, internal metallographic structure, surface finish and straightening degree of the material meet the raw material processing requirements for the production of standard parts and other metal products. Therefore, the pretreatment quality of the wire or bar by the wire drawing machine is directly related to the product quality of the standard parts and other metal product manufacturers. The wire drawing machine belongs to the metal wire drawing machine in the metal product equipment industry. The wire drawing machine is widely used in the production and preprocessing of metal products such as steel wire, rope wire, prestressed steel wire, and standard parts.

How much is the metal wire drawing machine

If the stainless steel wire drawing machine is classified according to the relationship between the controlled variable and the production process, two types of direct index control and indirect index control can be obtained. If the controlled variable itself is a process index that needs to be controlled, it will be called direct index control. Index control. If the process is operated according to the quality index, it will be controlled as a controlled variable, but in reality, sometimes there is a lack of various suitable inspection methods to obtain quality signals, so the direct index will be selected as the indirect control index to carry out Indirect index control. What I said above is about the two relationships between the stainless steel wire drawing machine and the controlled variable. Can you understand it?

When the wire drawing machine is working, the most fearful thing is to see that the drawing speed is unstable, sometimes fast and sometimes slow, so that the roughly drawn wire has intermittent and irregular changes. The occurrence of this phenomenon is related to each component of the wire drawing machine, because if the wire vibrates on the annealing wheel, this will happen, because the wire is annealed in a state of looseness and tension , so the surface of the line cannot be kept consistent. However, it may also be caused by the wear and tear caused by the long-term use of the gearbox of the main motor of the wire drawing machine. thin. On the other hand, the tension on the wire storage wheel of the wire drawing machine is unstable. In the final analysis, the air pressure of the air pump of the wire drawing machine varies from time to time, so that the pulling force on the wire drawing machine cannot be kept constant. It is because of the above three major problems that the production quality of the wire drawing machine is not ideal, so in the production process in the future, we must focus on this aspect and try to avoid it.